Turn the ignition one turn of the key or one press of the START/STOP button.Press and hold the SET/RESET button on the instrument cluster for 10 seconds.The upper display will be illuminated with a service item.The lower display will indicate the remaining time or mileage left for the service item.Pressing the button repeatedly will allow the display to scroll through all of the condition Automotive Mechanic. 35 years of experience. The "Service Engine Soon" (SES) notification signifies that scheduled maintenance is required. The SES light will illuminate based on elapsed time as well as the car’s mileage and operating conditions versus a predetermined maintenance schedule. The SES light might also illuminate if engine oil is low. How do you reset the brake fluid light on a BMW f30? Without pressing the brake/clutch, press the start/stop button. Wait for the service reminder to disappear. Press and hold the odometer reset button. At the value you want to reset, press and hold the odometer reset button. Press and hold odometer reset button again until value is reset. Release the button again. Press and hold the button for a third time. The message will say, “Reset in Progress.”. Continue to press and hold the button until the message says, “Reset Successful.”. Turn the car completely off. Start your engine to make sure the light was successfully reset. In the last few days the "low coolant" light has been intermittently turning on on my friend's BMW X3 (2007 ~70K miles). The light is not constantly on yet. I checked the coolant reservoir and float stick was slightly below the "low line". Nevertheless, the float stick was still floating and there was still some fluid left inside the reservoir. I have a 2008 X3 with 62,000 miles I just picked up. I'm now getting the Airbag (SRS), 4x4 warning light, and yellow brake warning lights, see attached photos. I checked the cables under both seats and tried to ensure all visible plugs are fully seated. I have the cheapo 1.3.6 china scanner and getting a traction control, ABS, and SRS code. Easy to do though; just press & hold buttons 1 & 3 - the light will blink fast. When the light turns solid, the opener has been reset. Takes less than 1 minute. Yes, step 1 of the programming it. Actually I got half a dozen of glitches and hoping that the Factory Reset would fix them but it did not. 2013 BMW X3 Maintenance Light Reset Instructions. January 30, 2017 / Instructions. You can watch our YouTube video on how to reset this light. 1. Turn ignition to Terminal 15 which is one turn of the key or one press of the START/STOP button. 2. Press and hold the Instrument Cluster Set/Reset button for 10 seconds. 3. Follow through and it should take around 3 times turning on and off the car, keep in mind you have to have the foot on the brake and button at all times,exce 2. Press and hold only button on bottom left of tacho /instrument display. 3. Display will change and show brake pad wear indicator picture. 4. Press (and release) same button again to scroll through menu. 5. When you reach the engine oil option (pic) press and hold until option appears to reset interval. tEeV7FA.